Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ghostyroasty

Pages: [1]
1
The original in the first post

2
I received the same error. A week or so ago, I went ahead and reinstalled the OS... I'm receiving the same errors again.

3
I did, and after restarting, the same error occurred.. it's not a huge loss if I just reinstall, as there were only two programs I would have to install.

4
Sorry, I wasn't even thinking about copying and pasting since I'm used to the machine being in the state it is currently in... I received the same error after rebooting. On the line that includes the command xed, I received a connection refused error, so I used sudo nano and saved the alterations that way.

Here is the error when using the xed command:
Code: [Select]
No protocol specified
Unable to init server: Could not connect: Connection refused

(xed:3306): Gtk-WARNING **: 12:18:31.786: cannot open display: :0.0

5
Sorry for the delay!!

6
Tried holding shift with no success and also tried tapping it also with no success.. I never reached any other menu, it always boots directly to the image shown on my original post.

7
Away from home for a bit, it I would test.. but from trying several things before, I am unable to type anything in, well at least nothing appears on the screen while trying to type.

8
I have a Z83-W I currently use for an Emby and Plex Media server that no longer goes into the gui, and I cannot input anything. I have errors on the screen which I have attached to the post. PMS and Emby still load and serve content, but I cannot update anything due to not being able to input anything.

Pages: [1]